Flashing BIOS via hardware

If you can’t access the computer when it’s on, and the standard backdoor passwords didn’t work, you’ll have to flash the BIOS via hardware. Please read the important notes at the end of this section before to try any of these methods.

__________________________

Using the jumpers
The canonical way to flash the BIOS via hardware is to plug, unplug, or switch a jumper on the motherboard (for “switching a jumper” I mean that you find a jumper that joins the central pin and a side pin of a group of three pins, you should then unplug the jumper and then plug it to the central pin and to the pin on the opposite side, so if the jumper is normally on position 1-2, you have to put it on position 2-3, or vice versa). This jumper is not always located near to the BIOS, but could be anywhere on the motherboard.
To find the correct jumper you should read the motherboard’s manual.
Once you’ve located the correct jumper, switch it (or plug or unplug it, depending from what the manual says) while the computer is turned OFF. Wait a couple of seconds then put the jumper back to its original position. In some motherboards it may happen that the computer will automatically turn itself on, after flashing the BIOS. In this case, turn it off, and put the jumper back to its original position, then turn it on again. Other motherboards require you turn the computer on for a few seconds to flash the BIOS.

If you don’t have the motherboard’s manual, you’ll have to “brute force” it… trying out all the jumpers. In this case, try first the isolated ones (not in a group), the ones near to the BIOS, and the ones you can switch (as I explained before). If all them fail, try all the others. However, you must modify the status of only one jumper per attempt, otherwise you could damage the motherboard (since you don’t know what the jumper you modified is actually meant for). If the password request screen still appear, try another one.
If after flashing the BIOS, the computer won’t boot when you turn it on, turn it off, and wait some seconds before to retry.

__________________________

Removing the battery

If you can’t find the jumper to flash the BIOS or if such jumper doesn’t exist, you can remove the battery that keeps the BIOS memory alive. It’s a button-size battery somewhere on the motherboard (on elder computers the battery could be a small, typically blue, cylinder soldered to the motherboard, but usually has a jumper on its side to disconnect it, otherwise you’ll have to unsolder it and then solder it back). Take it away for 15-30 minutes or more, then put it back and the data contained into the BIOS memory should be volatilized. I’d suggest you to remove it for about one hour to be sure, because if you put it back when the data aren’t erased yet you’ll have to wait more time, as you’ve never removed it. If at first it doesn’t work, try to remove the battery overnight.

Important note: in laptop and notebooks you don’t have to remove the computer’s power batteries (which would be useless), but you should open your computer and remove the CMOS battery from the motherboard.